Fibaro Single Switch 2

279,00 kr. Inkl. moms

Fibaro Single Switch 2

På lager

Varenummer (SKU): FGS-213 Kategorier: ,


Fibaro Single Switch 2

FIBARO Switch 2 er designet til at blive installeret i standard vægkontaktdåse eller andre steder,
hvor det er nødvendigt at styre elektriske enheder.
FIBARO Switch 2 giver mulighed for at styre tilsluttede enheder enten via Z-Wave netværket eller via en kontakt,
der er tilsluttet direkte til den, og er udstyret med aktiv strøm- og energiforbrugsmålerfunktionalitet.
Single Switch 2 (FGS-213) – kan styre en elektriske enhed.

Compatible with any Z-Wave or Z-Wave+ Controller
Supports protected mode (Z-Wave network security mode) with AES-128 encryption
Advanced microprocessor control
Active power and energy metering functionality
Works with various types of switches – momentary, toggle, three-way, etc
To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions
of applicable regulations FIBARO Switch 2 is an extension unit

The Switch 2 may operate under the following loads:
Conventional incandescent light sources, Halogen light sources,
Electrical appliances which power consumption does not exceed the limit for a specified device.

Technical data:
Power supply: 100-240V~ 50/60 Hz
Rated load current: Single Switch 2 (FGS-213):
IEC standards: 8A
Operating temperature: 0-35°C
For installation in boxes: Ø ≥ 50mm, depth ≥ 60mm
Radio protocol: Z-Wave (500 series chip)
Radio signal power: up to 1mW
Radio frequency: 868.4 MHz EU
Radio transmit power: up to 6 dBm (EIRP)
Range: up to 50m outdoors up to 40m indoors (depending on terrain and building structure)
Comply with EU directives: RED 2014/53/EU RoHS 2011/65/EU
Dimensions (L x W x H): 42.5 x 38.25 x 20.3 mm

Fibaro Manual



Yderligere information

Vægt 0,1 kg
Størrelse 7 × 7 × 4 cm

Du kunne også være interesseret i...